IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 145 / 402

Using the ServeRAID Mini-Configuration
program
The ServeRAID Mini-Configuration program is a quick way
to view the ServeRAID controller settings and to perform a
limited set of the configuration functions. The ServeRAID
Mini Configuration program is stored in read-only memory
(ROM).
To access the ServeRAID Mini-Configuration program:
1. Start the server. If the system is already turned on,
press Ctrl
+
Alt
+
Del to restart the server.
Each time the system starts, the ServeRAID controller
performs a power-on self-test (POST). The POST
checks the configuration information for the
ServeRAID controller and for the configured hard disk
drives, to see if any changes have occurred.
Ÿ
If POST does not detect changes in the
configuration or encounter any hardware
problems, continue with step 2.
Ÿ
If POST detects changes in the configuration or
encounters a hardware problem, messages
appear on the screen. If this occurs, see
“Symptom-to-FRU index” on page 264 and
correct the problem; then, return here and
continue with step 2.
2. Press Ctrl
+
I immediately when a screen similar to the
following Mini-Configuration screen appears.
Press <Ctrl+I> for Mini-Config Utility
Initializing Adapter Number 1. Please wait Starting drives.
Firmware Version: NNNNN
NvRAM cache controller was found.
4 logical drives are installed.
NonDisk SCSI Devices Found : CDROM: 0
Tape: 0 Removable Disk: 1 Other: 0
IBM ServeRAID Adapter BIOS
Copyright IBM Corp. 1995, 1997
Ver: X.XX.X MM/DD/YY
IBM ServeRAID Adapter Disk Array Mini-Configuration Utility Ver. X.XX
Note
In the preceding figure, the version number will
be replaced by the version number of the
Mini-Configuration program, the MM/DD/YY will
be replaced by the date of the version of the
Mini-Configuration program, and NNNNN will be
replaced by the version number of the firmware.
Netfinity 5500 - Type 8660
137