IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 80 / 402

3. Start (or restart) the server.
Ÿ
If the remote server is currently powered off:
a. Select 6 System Power from the main
menu.
b. Select 4 Power On from the System Power
menu.
Ÿ
If the server is currently powered on, you must
restart the server. You can use selections from
the System Power menu or the Boot menu to
restart the server in several ways.
To restart the server using System Power menu
selection:
a. Select 6 System Power from the main
menu.
b. Select 3 Power Off from the System Power
menu.
c. Once the server has powered off, select 4
Power On to restore power to the server.
To restart the server using Boot menu
selections:
a. Select 7 Boot from the main menu.
b. Select either 1 Reboot w/OS Shutdown or
2 Reboot Immediately to restart the
server.
Note
For information on the System Power and
Boot menus, see “System Power menu
selections” on page 68 and “Boot menu
selections” on page 69.
4. After you restart the server, return to the main menu
and select Z Start Remote Video.
Once you have started Remote Video mode on the system
management processor, all textual output generated during
POST will be sent to the terminal window. The terminal
will also act as a fully-active remote session, enabling you
to enter keyboard commands that will be sent to the
remote server. In this way, you can enter key commands
and key-combinations that access POST operations and
utilities such as system setup or the RAID
mini-configuration program.
When you have finished using Remote Video mode, press
Ctrl+R, then press Ctrl+E, and then press Ctrl+T. This
will end Remote Video mode and return you to the main
menu.
72
Netfinity Server HMM