IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 218 / 402

Removing the rear panel
Note
Do not remove the rear panel if you are not installing
a device in the NetBAY3.
1. Remove the NetBAY3 rear panel.
a. Remove the four screws.
b. Lift the rear panel off.
2. After you remove the rear panel, do one of the
following:
Ÿ
Install a device on rails in the NetBAY3. (Go to
“Installing devices on side rails.”)
Ÿ
Install a cantilevered device in the NetBAY3.
(Go to “Installing cantilevered devices” on
page 212.)
Ÿ
Install a device on the NetBAY3 base plate. (Go
to “Installing devices on the NetBAY3 base plate”
on page 213.)
Installing devices on side rails:
Installing
devices that sit on side rails in a NetBAY3 is similar to
installing these devices in a rack enclosure. The device
side rails must be screwed to the NetBAY3 vertical
mounting rails. Follow the instructions in the
documentation that comes with the device and use the
following illustrations as a guide.
If you need to remove or move the cage nuts at the rear of
the NetBAY3 to hold the rails, go to “Removing cage nuts”
on page 211.
210
Netfinity Server HMM