IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 254 / 402

Removing the server from a rack
Before you begin
Ÿ
Read “Safety information” on page 308.
Ÿ
Turn off the server.
Ÿ
Follow any additional installation and safety
instructions that come with the rack.
To remove the server from a rack:
1. If you have a modem or fax machine attached to the
server, disconnect the telephone line from the
electrical outlet and the server.
Note
If you are in the United Kingdom, you must
perform this step before disconnecting the power
cords.
2. Disconnect all cables and power cords from the rear
of the server.
3. Disconnect all power cords from the rack.
4. Remove the screws from the bezel brackets on each
side of the front bezel. Set them aside for later use.
5. Slide the server about halfway out of the rack.
6. Loosen the captive screws that secure the
cable-management arm.
7. Fully extend the slide-bracket assemblies until they
lock.
8. Remove the screws that attach the server to each
slide-bracket assembly.
246
Netfinity Server HMM