IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 215 / 402

.3/
Screws for half-high drive
.4/
Screw holes for slim-high drive
.5/
Drive tray
.6/
Drive
.7/
Connector for half-high drive
.8/
Screws for half-high drive connector
To replace a drive in a hot-swap bay:
1. Unlock and open the server door (see “Preparing to
install options” on page 220).
Attention:
To maintain proper system cooling, do not operate
the server for more than two minutes without either a
drive or a filler panel installed for each bay.
2. Remove the defective hard disk drive
.1/
by placing
the handle
.2/
on the drive to the open position
(perpendicular to the drive) and pulling the hot-swap
tray from the bay.
3. Remove the hard disk drive from the tray:
a. If the drive is a half-high drive, remove the two
screws
.8/
that hold the connector
.7/
to the
Netfinity 5500 - Type 8660
207