IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 259 / 402

Server cabling
Make sure you have an adequate number of properly
grounded electrical outlets for the server, monitor, and any
other options that you installed. Place the server in a
location that is dry. Rain or spilled liquids might damage
the server. Leave about 50 mm (2 inches) of space at the
right and left sides of the server to allow the server's
cooling system to work properly. Leave about 100 mm (4
inches) clearance at the rear for cables.
1. Use the illustration in “Input/Output connectors and
expansion slots” on page 194 to cable the server.
2. Remove any shipping screws
.2/
from the power
supply.
3. Connect the power cord
.1/
to the server.
Caution.
When the power-cord strain-relief bracket option
is installed on the power cord, the server must be
plugged to a power source that is easily
accessible.
4. Install the power-cord strain-relief bracket
.3/
(if
desired).
5. Plug the power cord into a properly grounded
electrical outlet.
Netfinity 5500 - Type 8660
251