IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 210 / 402

.5/
Drive
.6/
SCSI cable for the removable-media drive bays
.7/
Shuttle
.8/
Thumbscrews
To install a removable-media drive in one of the left
front bays:
1. Turn off the server and peripheral devices (see
“Preparing to install options” on page 220) and
remove the top cover (see “Top cover removal” on
page 262).
2. Remove the NetBAY3 bezel and the media-bay trim
bezel. (See “Server door and trim bezels removal” on
page 252.)
3. Remove the screws
.1/
and filler panel
.2/
from the
bay opening. Save screws for later use in this
procedure. You do not need the filler panel when you
have a drive installed in the bay.
4. Touch the static-protective bag containing the drive to
any unpainted metal surface on the server; then,
remove the drive from the bag and place it on a
static-protective surface.
5. Set any jumpers or switches on the drive according to
the documentation that comes with the drive.
6. Use screws
.4/
of the appropriate size and length to
attach a slide rail
.3/
to each side of the drive
.5/
.
Note
The slide rails and screws are included in the
drive accessory kit that comes with the server.
7. Place the drive so that the slide rails engage in the
bay guide rails. Push the drive into the bay and
attach it with the two screws
.1/
from the filler panel.
8. Loosen the four thumbscrews
.8/
on the shuttle at
the back of the server.
202
Netfinity Server HMM