IBM 866011U - Netfinity 5500 - 8660, Hardware Maintenance Manual

Page: 212 / 402

.1/
Filler panel
.2/
Hot-swap hard disk drive
.3/
Drive tray handle (open position)
To install a drive in a hot-swap bay:
1. Unlock and open the server door (see “Preparing to
install options” on page 220).
Attention:
To maintain proper system cooling, do not operate
the server for more than two minutes without either a
drive or a filler panel installed for each bay.
2. Remove the filler panel(s)
.1/
from one of the empty
hot-swap bays by inserting your finger into the
depression at the left side of the filler panel and
pulling it away from the server.
3. Install the hard disk drive
.2/
in the hot-swap bay:
a. Ensure the tray handle
.3/
is open (that is,
perpendicular to the drive).
b. Align the drive/tray assembly so that it engages
the guide rails in the bay.
c. Gently push the drive assembly into the bay until
the drive connects to the backplane.
d. Push the tray handle to the right until it locks.
4. Check the hard disk drive status indicators to verify
that the hard disk drives are operating properly.
5. Close and lock the server door.
204
Netfinity Server HMM