set system location
Enterasys G-Series CLI Reference 2-23
Example
This
example
shows
how
to
set
the
system
name
to
Information
Systems:
G3(su)->set system name “Information Systems”
set system location
Use
this
command
to
identify
the
location
of
the
system.
Syntax
set system location
[
string
]
Parameters
Defaults
If
string
is
not
specified,
the
location
name
will
be
cleared.
Mode
Switch
command,
read
‐
write.
Example
This
example
shows
how
to
set
the
system
location
string:
G3(su)->set system location “Bldg N32-04 Closet 9”
set system contact
Use
this
command
to
identify
a
contact
person
for
the
system.
Syntax
set system contact
[
string
]
Parameters
Defaults
If
string
is
not
specified,
the
contact
name
will
be
cleared.
string
(Optional)
Specifies
a
text
string
that
indicates
where
the
system
is
located.
Note:
A location string containing a space in the text must be
enclosed in quotes as shown in the example below.
string
(Optional)
Specifies
a
text
string
that
contains
the
name
of
the
person
to
contact
for
system
administration.
Note:
A contact string containing a space in the text must be enclosed
in quotes as shown in the example below.
Summary of Contents for G3G170-24
