Enterasys G3G170-24, Cli Reference Manual

Page: 123 / 679

set lldp trap-interval
Enterasys G-Series CLI Reference 3-23
set lldp trap-interval
Use this command to set the minimum interval between LLDP notifications sent by this device.
LLDP notifications are sent when a remote system change has been detected.
Syntax
s et lldp trap-interval frequency
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example sets the minimum interval between LLDP traps to 10 seconds.
G3(rw)->set lldp trap-interval 10
set lldp med-fast-repeat
Network connectivity devices transmit only LLDP TLVs in LLDPDUs until they detect that an
LLDP ‐ MED endpoint device has connected to a port. At that point, the network connectivity
device starts sending LLDP ‐ MED TLVs at a fast start rate on that port. Use this command to set
the number of successive LLDPDUs (with LLDP ‐ MED TLVs) to be sent for one complete fast start
interval.
Syntax
set lldp med-fast-repeat count
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
frequency Specifies the minimum time between LLDP trap transmissions, in
seconds. The value can range from 5 to 3600 seconds. The default
value is 5 seconds.
count Specifies the number of fast start LLDPDUs to be sent when an
LLDP ‐ MED endpoint device is detected. Value can range from 1 to
10. Default is 3.