Enterasys G3G170-24, Cli Reference Manual

Page: 37 / 679

Factory Default Settings
Enterasys G-Series CLI Reference 1-3
Jumbo frame support Enabled on all ports.
Link aggregation control
protocol (LACP) Enabled.
Link aggregation admin
key Set to 32768 for all ports.
Link aggregation flow
regeneration Disabled.
Link aggregation system
priority Set to 32768 for all ports.
Link aggregation outport
algorithm Set to DIP-SIP.
Lockout Set to disable Read-Write and Read-Only users, and to lockout the default
admin (Super User) account for 15 minutes, after 3 failed login attempts.
Logging Syslog port set to UDP port number 514. Logging severity level set to 6
(significant conditions) for all applications.
MAC aging time Set to 300 seconds.
MAC locking Disabled (globally and on all ports).
Passwords Set to an empty string for all default user accounts. User must press ENTER
at the password prompt to access CLI.
Password aging Disabled.
Password history No passwords are checked for duplication.
Policy classification Classification rules are automatically enabled when created.
Port auto-negotiation Enabled on all ports.
Port advertised ability Maximum ability advertised on all ports.
Port broadcast suppression Enabled and set to limit broadcast packets to 14,881 per second on all switch
ports.
Port duplex mode Set to half duplex, except for 100BASE-FX and 1000BASE-X, which is set to
full duplex.
Port enable/disable Enabled.
Port priority Set to 0.
Port speed Set to 10 Mbps, except for 1000BASE-X, which is set to 1000 Mbps, and
100BASE-FX, which is set to 100 Mbps.
Port trap All ports are enabled to send link traps.
Power over Ethernet port
admin state Administrative state is on (auto).
Priority classification Classification rules are automatically enabled when created.
RADIUS client Disabled.
RADIUS last resort action When the client is enabled, set to Challenge.
RADIUS retries When the client is enabled, set to 3.
RADIUS timeout When the client is enabled, set to 20 seconds.
Table 1-1 Default Settings for Basic Switch and Router Operation (Continued)
Feature Default Setting