Enterasys G3G170-24, Cli Reference Manual

Page: 636 / 679

show multiauth port
20-34 Security Configuration
show multiauth port
Use this command to display multiple authentication properties for one or more ports.
Syntax
show multiauth port [ port-string ]
Parameters
Defaults
If port ‐ string is not specified, multiple authentication information will be displayed for all ports.
Mode
Switch command, read ‐ only.
Example
This example shows how to display multiple authentication information for ports
ge
.3.1 ‐ 4:
G3(rw)->show multiauth port ge.3.1-4
Port Mode Max Allowed Current
users users users
------------ ------------ ---------- ---------- ----------
ge.3.1 auth-opt
8 8 0
ge.3.2 auth-opt 8 8 0
ge.3.3 auth-opt 8 8 0
ge.3.4 auth-opt 8 8 0
set multiauth port
Use this command to set multiple authentication properties for one or more ports.
Syntax
set multiauth port mode { auth-opt | auth-reqd | force-auth | force-unauth } |
numusers numusers port-string
Parameters
port ‐ string (Optional) Displays multiple authentication information for specific port(s).
mode
auth ‐ opt |
auth ‐ reqd |
force ‐ auth |
force ‐ unauth
Specifies the port(s)’ multiple authentication mode as:
• auth ‐ opt — Authentication optional (“non ‐ strict” behavior). If a user
does not attempt to authenticate using 802.1x, or if 802.1x
authentication fails, the port will allow traffic to be forwarded
according to the defined default VLAN.
• auth ‐ reqd — Authentication is required.
• force ‐ auth — Authentication considered.
• force ‐ unauth — Authentication disabled.
numusers
numusers
Specifies the number of users allowed authentication on port(s). Valid
values are 0 to 8.