Enterasys G3G170-24, Cli Reference Manual

Page: 333 / 679

set port txq
Enterasys G-Series CLI Reference 9-7
Parameters
Defaults
If the port ‐ string is not specified, the QoS setting of all physical ports will be displayed.
Mode
Switch command, read ‐ only.
Example
This example shows how to display the current algorithm and transmit queue weights configured
on port
ge
.1.10:
G3(su)->show port txq ge.1.10
Port Alg Q0 Q1 Q2 Q3 Q4 Q5 Q6 Q7
----- --- --- --- --- --- --- --- --- ---
ge.1.10 WRR 10 10 15 20 25 20 0 0
set port txq
Use this command to set QoS transmit queue arbitration values for physical ports.
Syntax
set port txq port-string value0 value1 value2 value3 value4 value5 value6 value7
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
port ‐ string (Optional) Specifies port(s) for which to display QoS settings. For a
detailed description of possible port ‐ string values, refer to “ Port String
Syntax Used in the CLI ” on page 4 ‐ 1.
Only physical ports will be displayed. LAG ports have no transmit queue
information.
port ‐ string Specifies port(s) on which to set queue arbitration values. For a detailed
description of possible port ‐ string values, refer to “ Port String Syntax Used
in the CLI ” on page 4 ‐ 1.
Only physical ports can be configured with this command. LAG ports
cannot be configured.
value0 ‐ value7 Specifies percentage to allocate to a specific transmit queue. The values
must total 100 percent.