Enterasys G3G170-24, Cli Reference Manual

Page: 487 / 679

show ip ospf virtual-links
Enterasys G-Series CLI Reference 16-29
If ip ‐ address is not specified, OSPF neighbors will be displayed for all IP addresses configured for
routing.
If vlan ‐ id is not specified, OSPF neighbors will be displayed for all VLANs configured for routing.
Mode
Any router mode.
Example
This example shows how to use the show ospf neighbor command:
G3(su)->router#show ip ospf neighbor
ID Pri
State Dead-Int Address Interface
182.127.62.1 1 FULL 40 182.127.63.1 vlan1
Table 16 ‐ 5 provides an explanation of the command output.
show ip ospf virtual-links
Use this command to display information about the virtual links configured on a router. A virtual
link represents a logical connection between the backbone and a non ‐ backbone OSPF area.
Syntax
show ip ospf virtual-links
Parameters
None.
Defaults
None.
Mode
Any router mode.
Table 16-5 show ip ospf neighbor Output Details
Output Field What It Displays...
ID Neighbor’s router ID of the OSPF neighbor.
Pri Neighbor’s priority over this interface.
State Neighbor’s OSPF communication state.
Dead-Int Interval (in seconds) this router will wait without receiving a Hello packet from a
neighbor before declaring the neighbor is down.
Address Neighbor’s IP address.
Interface Neighbor’s interface (VLAN).