Enterasys G3G170-24, Cli Reference Manual

Page: 477 / 679

distance ospf
Enterasys G-Series CLI Reference 16-19
Syntax
ip ospf message-digest-key keyid md5 key
no ip ospf message-digest-key keyid
Parameters
Defaults
None.
Mode
Interface configuration: G3
(su) ‐ >router(Config ‐ if(Vlan 1))#
Example
This example shows how to enable OSPF MD5 authentication on the VLAN 1 interface, set the key
identifier to 20, and set the password to “passone”:
G3(su)->router(Config)#interface vlan 1
G3(su)->router(Config-if(Vlan 1))#ip ospf message-digest-key 20 md5 passone
distance ospf
Use this command to configure the administrative distance for OSPF routes. The no form of this
command resets OSPF administrative distance to the default values.
Syntax
distance ospf { external | inter-area | intra-area } weight
no distance ospf { external | inter-area | intra-area }
Parameters
Defaults
If route type is not specified, the distance value will be applied to all OSPF routes.
Mode
Router configuration: G3 (su) ‐ >router(Config ‐ router)#
keyid Specifies the key identifier on the interface where MD5 authentication is
enabled. Valid values are integers from 1 to 255 .
key Specifies a password for MD5 authentication to be used with the keyid . Valid
values are alphanumeric strings of up to 16 characters.
external | inter ‐
area | intra ‐ area
Applies the distance value to external (type 5 and type 7), to inter ‐ area, or to
intra ‐ area routes.
Note: The value for intra-area distance must be less than the value for
inter-area distance, which must be less than the value for external distance.
weight Specifies an administrative distance for OSPF routes. Valid values are 1 ‐
255 .