Enterasys G3G170-24, Cli Reference Manual

Page: 143 / 679

show port duplex
Enterasys G-Series CLI Reference 4-11
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to set
ge
.3.3 to a port speed of 10 Mbps:
G3(su)->set port speed ge.3.3 10
show port duplex
Use this command to display the default duplex setting (half or full) for one or more ports.
Syntax
show port duplex [ port-string ]
Parameters
Defaults
If port ‐ string is not specified, default duplex settings for all ports will be displayed.
Mode
Switch command, read ‐ only.
Example
This example shows how to display the default duplex setting for Gigabit Ethernet port 14 in
slot 3:
G3(su)->show port duplex ge.3.14
default duplex mode is full on port ge.3.14.
set port duplex
Use this command to set the default duplex type for one or more ports. This command will only
take effect on ports that have auto ‐ negotiation disabled.
Syntax
set port duplex port-string { full | half }
10 | 100 | 1000 Specifies the port speed. Valid values are: 10 Mbps, 100 Mbps, or
1000 Mbps.
port ‐ string (Optional) Displays default duplex setting(s) for specific port(s).
For a detailed description of possible port ‐ string values, refer to
“ Port String Syntax Used in the CLI ” on page 4 ‐ 1.