Enterasys G3G170-24, Cli Reference Manual

Page: 295 / 679

set garp timer
Enterasys G-Series CLI Reference 7-23
Example
This example shows how to clear GVRP status globally on the device:
G3(su)->clear gvrp
set garp timer
Use this command to adjust the values of the join, leave, and leaveall timers.
Syntax
set garp timer {[ join timer-value ] [ leave timer-value ] [ leaveall timer-value ]}
port-string
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Usage
The setting of these timers is critical and should only be changed by personnel familiar with the
802.1Q standards documentation, which is not supplied with this device.
Examples
This example shows how to set the GARP join timer value to 100 centiseconds for all ports:
G3(su)->set garp timer join 100 *.*.*
This example shows how to set the leave timer value to 300 centiseconds for all ports:
G3(su)->set garp timer leave 300 *.*.*
This example shows how to set the leaveall timer value to 20000 centiseconds for all ports:
G3(su)->set garp timer leaveall 20000 *.*.*
join timer ‐ value Sets the GARP join timer in centiseconds (Refer to 802.1Q standard.)
leave timer ‐ value Sets the GARP leave timer in centiseconds (Refer to 802.1Q standard.)
leaveall timer ‐
value
Sets the GARP leaveall timer in centiseconds (Refer to 802.1Q standard.)
port ‐ string Specifies the port(s) on which to configure GARP timer settings. For a
detailed description of possible port ‐ string values, refer to “ Port String
Syntax Used in the CLI ” on page 4 ‐ 1.