Enterasys G3G170-24, Cli Reference Manual

Page: 106 / 679

show neighbors
3-6 Discovery Protocol Configuration
show neighbors
This command displays Neighbor Discovery information for either the CDP or Cisco DP
protocols.
Syntax
show neighbors [ port-string ]
Parameters
Defaults
If no port is specified, all Neighbor Discovery information is displayed.
Mode
Switch command, read ‐ only.
Usage
This command displays information discovered by both the CDP and the Cisco DP protocols.
Example
This example displays Neighbor Discovery information for all ports.
G3(su)->show neighbors
Port Device ID Port ID Type Network Address
------------------------------------------------------------------------------
ge.1.1 00036b8b1587 12.227.1.176 ciscodp 12.227.1.176
ge.1.6 0001f496126f 140.2.3.1 ciscodp 140.2.3.1
ge.1.6 00-01-f4-00-72-fe 140.2.4.102 cdp 140.2.4.102
ge.1.6 00-01-f4-00-70-8a 140.2.4.104 cdp 140.2.4.104
ge.1.6 00-01-f4-c5-f7-20 140.2.4.101 cdp 140.2.4.101
ge.1.6 00-01-f4-89-4f-ae 140.2.4.105 cdp 140.2.4.105
ge.1.6 00-01-f4-5f-1f-c0 140.2.1.11 cdp 140.2.1.11
ge.1.19 0001f400732e 165.32.100.10 ciscodp 165.32.100.10
Configuring Cisco Discovery Protocol
Purpose
To review and configure the Cisco discovery protocol. Discovery protocols are used to discover
network topology. When enabled, they allow Cisco devices to send periodic PDUs about
themselves to neighboring devices. Specifically, this feature enables recognizing PDUs from Cisco
phones. A table of information about detected phones is kept by the switch and can be queried by
the network administrator.
port ‐ string (Optional) Specifies the port or ports for which to display Neighbor
Discovery information.