Enterasys G3G170-24, Cli Reference Manual

Page: 485 / 679

show ip ospf interface
Enterasys G-Series CLI Reference 16-27
show ip ospf interface
Use this command to display OSPF interface related information, including network type,
priority, cost, hello interval, and dead interval.
Syntax
show ip ospf interface [ vlan vlan-id ]
Parameters
Defaults
If vlan ‐ id is not specified, OSPF statistics will be displayed for all VLANs.
Mode
Any router mode.
Example
This example shows how to display all OSPF related information for the VLAN 6 interface:
G3(su)->router#show ip ospf interface vlan 6
Vlan 6
Internet Address 192.168.6.2 Mask 255.255.255.0, Area 0.0.0.0
Router ID 3.3.3.3 , Cost: 10 (computed)
Transmit Delay is 1 sec , State designated-router , Priority 1
Designated Router id 3.3.3.3 , Interface Addr 192.168.6.2
Backup Designated Router id 2.2.2.2 ,
Timer intervals configured , Hello 10 , Dead 40 , Retransmit 5
Table 16 ‐ 4 provides an explanation of the command output.
Table 16-3 show ip ospf database Output Details
Output Field What It Displays...
Link ID Link ID, which varies as a function of the link state record type, as follows:
• Net Link States - Shows the interface IP address of the designated router to the
broadcast network.
• Router Link States - Shows the ID of the router originating the record.
• Summary Link States - Shows the summary network prefix.
ADV Router Router ID of the router originating the link state record.
Age Age (in seconds) of the link state record.
Seq# OSPF sequence number assigned to each link state record.
Checksum Field in the link state record used to verify the contents upon receipt by another
router.
LinkCount Link count of router link state records. This number is equal to, or greater than, the
number of active OSPF interfaces on the originating router.
vlan vlan ‐ id (Optional) Displays OSPF information for a specific VLAN. This VLAN
must be configured for IP routing as described in “ Pre ‐ Routing
Configuration Tasks ” on page 14 ‐ 1.