Enterasys G3G170-24, Cli Reference Manual

Page: 126 / 679

set lldp port tx-tlv
3-26 Discovery Protocol Configuration
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
After you configure a location information value, you must also configure the port to send the
Location Information TLV with the set lldp port tx ‐ tlv command. This example configures the
ELIN identifier 5551234567 on ports
ge
.1.1 through
ge
.1.6 and then configures the ports to send
the Location Information TLV.
G3(rw)->set lldp port location-info 5551234567 ge.1.1-6
G3(rw)->set lldp port tx-tlv med-loc ge.1.1-6
set lldp port tx-tlv
Use this command to select the optional LLDP and LLDP ‐ MED TLVs to be transmitted in
LLDPDUs by the specified port or ports. Use the show lldp port local ‐ info command to display
the values of these TLVs for the port.
Syntax
set lldp port tx-tlv {[ all ] | [ port-desc ] [ sys-name ] [ sys-desc ] [ sys-cap ] [ mgmt-
addr ] [ vlan-id ] [ stp ] [ lacp ] [ gvrp ] [ mac-phy ] [ poe ] [ link-aggr ] [ max-frame ] [ med-
cap ] [ med-loc ] [ med-poe ]} port-string
Parameters
elin Specifies that the ECS ELIN data format is to be used.
elin ‐ string Specifies the location identifier. Value can be from 10 to 25 numerical
characters.
port ‐ string Specifies the port or range of ports to be affected.
all Adds all optional TLVs to transmitted LLDPDUs.
port ‐ desc Port Description optional basic LLDP TLV. Value sent is ifDescr
object defined in RFC 2863.
sys ‐ name System Name optional basic LLDP TLV. Value sent is the
administratively assigned name for the system.
sys ‐ desc System Description optional basic LLDP TLV. Value sent is sysDescr
object defined in RFC 3418.
sys ‐ cap System Capabilities optional basic LLDP TLV. For a network
connectivity device, value sent can be bridge and/or router.
mgmt ‐ addr Management Address optional basic LLDP TLV. Value sent is IPv4
address of host interface.
vlan ‐ id Port VLAN ID IEEE 802.1 Extensions TLV. Value sent is port VLAN
ID (PVID).