Enterasys G3G170-24, Cli Reference Manual

Page: 634 / 679

clear multiauth mode
20-32 Security Configuration
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Usage
Multiauth multi mode requires that MAC, PWA, and 802.1X authentication be enabled globally,
and configured appropriately on the desired ports according to their corresponding command
sets described in this chapter. Refer to “ Configuring 802.1X Authentication ” on page 20 ‐ 10 and
“ Configuring MAC Authentication ” on page 20 ‐ 19 and “ Configuring Port Web Authentication
(PWA) ” on page 20 ‐ 57.
Example
This example shows how to enable simultaneous multiple authentications:
G3(rw)->set multiauth mode multi
clear multiauth mode
Use this command to clear the system authentication mode.
Syntax
clear multiauth mode
Parameters
None.
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to clear the system authentication mode:
G3(rw)->clear multiauth mode
set multiauth precedence
Use this command to set the system’s multiple authentication administrative precedence.
multi Allows the system to use multiple authenticators simultaneously (802.1x,
PWA, and MAC Authentication) on a port. This is the default mode.
strict User must authenticate using 802.1x authentication before normal traffic
(anything other than authentication traffic) can be forwarded.