Enterasys G3G170-24, Cli Reference Manual

Page: 367 / 679

clear arp
Enterasys G-Series CLI Reference 11-17
clear arp
Use this command to delete a specific entry or all entries from the switch’s ARP table.
Syntax
clear arp { ip-address | all }
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to delete entry 10.1.10.10 from the ARP table:
G3(su)->clear arp 10.1.10.10
traceroute
Use this command to display a hop ‐ by ‐ hop path through an IP network from the device to a
specific destination host. Three UDP or ICMP probes will be transmitted for each hop between the
source and the traceroute destination.
Syntax
traceroute [ -w waittime ] [ -f first-ttl ] [ -m max-ttl ] [ -p port ] [ -q nqueries ] [ -r ]
[ -d ] [ -n ] [ -v ] host
Parameters
ip ‐ address | all Specifies the IP address in the ARP table to be cleared, or clears all ARP
entries.
‐ w waittime (Optional) Specifies time in seconds to wait for a response to a probe.
‐ f first ‐ ttl (Optional) Specifies the time to live (TTL) of the first outgoing probe
packet.
‐ m max ‐ ttl (Optional) Specifies the maximum time to live (TTL) used in outgoing
probe packets.
‐ p port (Optional) Specifies the base UDP port number used in probes.
‐ q nqueries (Optional) Specifies the number of probe inquiries.
‐ r (Optional) Bypasses the normal host routing tables.
‐ d (Optional) Sets the debug socket option.
‐ n (Optional) Displays hop addresses numerically. (Supported in a future
release.)
‐ v (Optional) Displays verbose output, including the size and destination of
each response.
host Specifies the host to which the route of an IP packet will be traced.