Enterasys G3G170-24, Cli Reference Manual

Page: 315 / 679

set cos settings
Enterasys G-Series CLI Reference 8-19
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to clear the CoS state back to its default setting of disabled:
G3(su)->clear cos state
set cos settings
Use this command to configure a Class of Service entry in the CoS settings table.
Syntax
set cos settings cos-index priority priority [ tos-value tos-value ] [ irl-reference
irl-reference ]
Parameters
Defaults
If no optional parameters are specified, none will be applied.
Mode
Switch command, read ‐ write.
Usage
The CoS settings table takes individual class of service features and displays them as belonging to
a CoS entry. Essentially, it is used for CoS feature assignment. Each class of service entry consists
of an index, 802.1p priority, an optional ToS value, and an IRL reference.
• CoS Index
Indexes are unique identifiers for each CoS setting. CoS indexes 0 through 7 are created by
default and mapped directly to 802.1p priority for backwards compatibility. These entries
cannot be removed, and 802.1p priority values cannot be changed. When CoS is enabled,
indexes are assigned. Up to 256 CoS indexes or entries can be configured.
cos ‐ index Specifies a Class of Service entry. Valid values are 0 to 255 .
priority priority Specifies an 802.1d priority value. Valid values are 0 to 7 , with 0 being the
lowest priority. See Usage section below for more information.
tos ‐ value tos ‐ value (Optional) Specifies a Type of Service value.
irl ‐ reference
irl ‐ reference
(Optional) Set the inbound rate limiter associated with this entry. Valid
values are 0 to 99. See Usage section below for more information.