Enterasys G3G170-24, Cli Reference Manual

Page: 469 / 679

router id
Enterasys G-Series CLI Reference 16-11
router id
Use this command to set the OSPF router ID for the device. This IP address must be set manually
in order to run OSPF. The no form of this command removes the router ID for the device.
Syntax
router id ip-address
no router id
Parameters
Defaults
None.
Mode
Global configuration: G3(su) ‐ >router(Config)#
• Configure OSPF authentication. “ ip ospf authentication-key ” on page 16-18
“ ip ospf message digest key md5 ” on page 16-18
Configure OSPF Areas.
• Configure an administrative distance. “ distance ospf ” on page 16-19
• Define the range of addresses to be used
by Area Boundary Routers (ABRs).
“ area range ” on page 16-20
• Define an area as a stub area. “ area stub ” on page 16-21
• Set the cost value for the default route that
is sent into a stub area.
“ area default cost ” on page 16-21
• Define an area as an NSSA. “ area nssa ” on page 16-22
Create virtual links. “ area virtual-link ” on page 16-23
Enable redistribution from non-OSPF
routes. “ redistribute ” on page 16-24
Monitor and maintain OSPF. “ show ip ospf ” on page 16-25
“ show ip ospf neighbor ” on page 16-28
“ show ip ospf interface ” on page 16-27
“ show ip ospf neighbor ” on page 16-28
“ show ip ospf virtual-links ” on page 16-29
“ clear ip ospf process ” on page 16-30
Table 16-2 OSPF Configuration Task List and Commands (Continued)
To do this... Use these commands...
ip ‐ address Specifies the IP address that OSPF will use as the router ID.