Enterasys G3G170-24, Cli Reference Manual

Page: 206 / 679

clear snmp targetparams
5-24 SNMP Configuration
Defaults
None.
If not specified, security level will be set to noauthentication.
If not specified, storage type will be set to nonvolatile .
Mode
Switch command, read ‐ write.
Example
This example shows how to set SNMP target parameters named “v1ExampleParams” for a user
named “fred” using version 3 security model and message processing, and authentication:
G3(su)->set snmp targetparams v1ExampleParams user fred security-model usm
message-processing v3 authentication
clear snmp targetparams
Use this command to clear the SNMP target parameter configuration.
Syntax
clear snmp targetparams targetParams
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
user user Specifies an SNMPv1 or v2 community name or an SNMPv3 user name.
Maximum length is 32 bytes.
security ‐ model v1 |
v2c | usm
Specifies the SNMP security model applied to this target parameter as
version 1, 2c or 3 (usm).
message ‐
processing v1 | v2c
| v3
Specifies the SNMP message processing model applied to this target
parameter as version 1, 2c or 3.
noauthentication |
authentication |
privacy
(Optional) Specifies the SNMP security level applied to this target
parameter as no authentication, authentication (without privacy) or
privacy. Privacy specifies that messages sent on behalf of the user are
protected from disclosure.
volatile |
nonvolatile
(Optional) Specifies the storage type applied to this target parameter.
targetParams Specifies the name of the parameter in the SNMP target parameters table
to be cleared.