Enterasys G3G170-24, Cli Reference Manual

Page: 234 / 679

clear spantree mstmap
6-14 Spanning Tree Configuration
Syntax
set spantree mstmap fid [ sid sid ]
Parameters
Defaults
If sid is not specified, FID(s) will be mapped to Spanning Tree 0.
Mode
Switch command, read ‐ write.
Example
This example shows how to map FID 3 to SID 2:
G3(su)->set spantree mstmap 3 sid 2
clear spantree mstmap
Use this command to map a FID back to SID 0.
Syntax
clear spantree mstmap fid
Parameters
Defaults
If fid is not specified, all SID to FID mappings will be reset.
Mode
Switch command, read ‐ write.
Example
This example shows how to map FID 2 back to SID 0:
G3(su)->clear spantree mstmap 2
Note: Since any MST maps that are associated with GVRP-generated VLANs will be removed from
the configuration if GVRP communication is lost, it is recommended that you only create MST maps
on statically-created VLANs.
fid Specifies one or more FIDs to assign to the MST. Valid values are 1 ‐ 4093 ,
and must correspond to a VLAN ID created using the set vlan command .
sid sid (Optional) Specifies a Multiple Spanning Tree ID. Valid values are 1 ‐ 4094 ,
and must correspond to a SID created using the set msti command.
fid Specifies one or more FIDs to reset to 0.