Enterasys G3G170-24, Cli Reference Manual

Page: 135 / 679

Reviewing Port Status
Enterasys G-Series CLI Reference 4-3
Example
This example shows how to configure port ge.2.1 in the G3G ‐ 24SFP module to operate with a
100BASE ‐ FX transceiver installed. First, the module is verified as present in Slot 2, and the port
status is shown as operating as a 1000BASE ‐ SX port. After the 1 ‐ Gigabit transceiver is replaced
with the a 100 Mbps transceiver, the port is configured appropriately and the new settings are
verified.
G3(su)->show version
Slot Status Ports Model Serial Number Hw Version
---- -------- ----- ---------- ------------- --------------
1 Present 24 G3G170-24 0011223302 BCM56514 REV 1
2 Present 24 G3G-24SFP H03611239 BCM56512 REV 1
3
4
G3(su)->show port advertise ge.2.1
ge.2.1 capability advertised remote
-------------------------------------------------
10BASE-T no no no
10BASE-TFD no no no
100BASE-TX no no no
100BASE-TXFD yes no no
1000BASE-T no no no
1000BASE-TFD yes yes no
pause yes yes no
G3(su)->show port status ge.2.1
Alias Oper Admin Speed
Port (truncated) Status Status (bps) Duplex Type
--------- ------------ ------- ------- --------- ------- ------------
ge.2.1 Down Up N/A N/A 1000BASE-SX
G3(su)->set port negotiation ge.2.1 disable
G3(su)->set port advertise ge.2.1 100txfd
G3(su)->set port speed ge.2.1 100
G3(su)->set port duplex ge.2.1 full
G3(su)->show port status ge.2.1
Alias Oper Admin Speed
Port (truncated) Status Status (bps) Duplex Type
--------- ------------ ------- ------- --------- ------- ------------
ge.2.1 Down Up 100.0M full 100BASE-FX
For more information, refer to the commands in this chapter and to your G ‐ Series hardware
installation documentation.
Reviewing Port Status
Purpose
To display operating status, duplex mode, speed, port type, and statistical information about
traffic received and transmitted through one or all switch ports on the device.