Enterasys G3G170-24, Cli Reference Manual

Page: 317 / 679

show cos settings
Enterasys G-Series CLI Reference 8-21
show cos settings
Use this command to display Class of Service parameters.
Syntax
show cos settings [ cos-list ]
Parameters
Defaults
If not specified, all CoS entries will be displayed.
Mode
Switch command, read ‐ only.
Example
This example shows how to show all CoS settings:
G3(su)->show cos settings
CoS Index Priority ToS IRL
--------- ---------- ------- -----
0 0 * *
1 1 * *
2 2 * *
3 3 * *
4 4 * *
5 5 * *
6 6 * *
7 7 * *
set cos port-config
Use this command to create a port group for inbound rate limiting and add or remove ports from
the group.
Syntax
set cos port-config irl group-type-index [ name name ] [ ports port-list ] [ append ] |
[ clear ]
Parameters
cos ‐ list (Optional) Specifies a Class of Service entry to display.
irl Specifies that this is an inbound rate limiting (IRL) port group.
group ‐ type ‐ index Specifies an inbound rate limiting port group/type index. Valid entries
are in the form of group#.port ‐ type .
Valid values for group# can range from 0 to 7. Valid values for port ‐ type
can range from 0 to 1, although only port type 0 is currently supported.
For example, port group 3 would be specified as 3.0 .
name name (Optional) User defined name for the group .