Enterasys G3G170-24, Cli Reference Manual

Page: 170 / 679

set lacp
4-38 Port Configuration
set lacp
Use this command to disable or enable the Link Aggregation Control Protocol (LACP) on the
device.
Syntax
set lacp {disable | enable}
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Example
This example shows how to disable LACP:
G3(su)->set lacp disable
set lacp asyspri
Use this command to set the LACP system priority.
Syntax
set lacp asyspri value
Parameters
Defaults
None.
Mode
Switch command, read ‐ write.
Oper Key Port’s operational key, derived from the admin key. Only underlying physical ports
with oper keys matching the aggregator’s will be allowed to aggregate.
Attached Ports Underlying physical ports associated with this aggregator.
Table 4-6 show lacp Output Details (Continued)
Output Field What It Displays...
disable | enable Disables or enables LACP.
asyspri Sets the system priority to be used in creating a LAG (Link Aggregation
Group) ID. Valid values are 0 to 65535 .
value Specifies a system priority value. Valid values are 0 to 65535 , with
precedence given to lower values.