show ip address
Enterasys G-Series CLI Reference 2-9
show ip address
Use
this
command
to
display
the
system
IP
address
and
subnet
mask.
Syntax
show ip address
Parameters
None.
Defaults
None.
Mode
Switch
command,
read
‐
only.
Example
This
example
shows
how
to
display
the
system
IP
address
and
subnet
mask:
G3(su)->show ip address
Name Address Mask
---------------- ---------------- ----------------
host 10.42.13.20
255.255.0.0
set ip address
Use
this
command
to
set
the
system
IP
address,
subnet
mask
and
default
gateway.
Syntax
set ip address
ip-address
[
mask
ip-mask
] [
gateway
ip-gateway
]
Parameters
set system contact
2-23
set width
2-24
set length
2-24
show logout
2-25
set logout
2-25
show console
2-26
set console baud
2-27
For information about...
Refer to page...
Note:
The G3 does not support the ability for a user to configure the host's gateway to be a local
routed interface IP. The host's gateway must exist on a different device in the network if one is
configured.
ip
‐
address
Sets
the
IP
address
for
the
system.
.
Summary of Contents for G3G170-24
