Enterasys G3G170-24, Cli Reference Manual

Page: 102 / 679

show cdp
3-2 Discovery Protocol Configuration
Syntax
show cdp [ port-string ]
Parameters
Defaults
If port ‐ string is not specified, all CDP information will be displayed.
Mode
Switch command, read ‐ only.
Example
This example shows how to display CDP information for ports ge .1.1 through ge .1.9:
G3(su)->show cdp ge.1.1-9
CDP Global Status :auto-enable
CDP Version Supported :30 hex
CDP Hold Time :180
CDP Authentication Code :00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 hex
CDP Transmit Frequency :60
Port Status
-----------------
ge.1.1 auto-enable
ge.1.2 auto-enable
ge.1.3 auto-enable
ge.1.4 auto-enable
ge.1.5 auto-enable
ge.1.6 auto-enable
ge.1.7 auto-enable
ge.1.8 auto-enable
ge.1.9 auto-enable
Table 3 ‐ 1 provides an explanation of the command output.
port ‐ string (Optional) Displays CDP status for a specific port. For a detailed description
of possible port ‐ string values, refer to “ Port String Syntax Used in the CLI ”
on page 4 ‐ 1.
Table 3-1 show cdp Output Details
Output Field What It Displays...
CDP Global Status Whether CDP is globally auto-enabled, enabled or disabled. The default state of
auto-enabled can be reset with the set cdp state command. For details, refer to “
set
cdp state ” on page 3-3.
CDP Versions
Supported CDP version number(s) supported by the switch.
CDP Hold Time Minimum time interval (in seconds) at which CDP configuration messages can be
set. The default of 180 seconds can be reset with the set cdp hold-time command.
For details, refer to “
set cdp hold-time ” on page 3-5.
CDP Authentication
Code Authentication code for CDP discovery protocol. The default of 00-00-00-00-00-00-
00-00 can be reset using the set cdp auth command. For details, refer to “
set cdp
auth ” on page 3-3.