Dell Force10 S4810P, Reference Manual

Page: 1563 / 1637

Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
ntp disable
Prevent an interface from receiving NTP packets.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax ntp disable
To re-enable NTP on an interface, use the
no ntp disable
command.
Defaults Disabled (that is, if you configure an NTP host, all interfaces receive NTP packets)
Command Modes INTERFACE
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
ntp multicast client
Configure the switch to receive NTP information from the network via multicast.
E-Series, Z-Series, S4810
Syntax ntp multicast client [ multicast-address ]
To disable multicast reception, use the
no ntp multicast client [ multicast-
address ]
command.
Parameters
multicast-
address
(OPTIONAL) Enter a multicast address. Enter either an IPv4 address in
dotted decimal format or an IPv6 address in X:X:X:X::X format. If you
do not enter a multicast address, the address:
1563