Dell Force10 S4810P, Reference Manual

Page: 514 / 1637

neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
C-Series, E-Series
Syntax neighbor { ipv6-address | peer-group-name } route-map map-name
{in | out}
To remove the route map, use the
no neighbor { ipv6-address | peer-group-
name } route-map map-name {in | out}
command.
Parameters
ipv6-address
Enter the IPv6 address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of
zeros.
peer-group-name
Enter the name of the peer group.
map-name
Enter the name of an established route map. If you do not configure
the Route map, the default is
deny
(to drop all routes).
in Enter the keyword
in
to filter inbound routes.
out Enter the keyword
out
to filter outbound routes.
Defaults Not configured.
Command Modes ROUTER BGPV6-ADDRESS FAMILY
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Version 7.4.1.0 Introduced
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of
the route map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in
the Route map used in this command. If you identify a peer by IP address, the Route map
overwrites either the inbound or outbound policies on that peer.
neighbor route-reflector-client
Configure a neighbor as a member of a route reflector cluster.
C-Series, E-Series
Syntax neighbor { ipv6-address | peer-group-name } route-reflector-
client
To indicate that the neighbor is not a route reflector client or to delete a route reflector
configuration, use the
no neighbor { ipv6-address | peer-group-name }
route-reflector-client
command.
514