Dell Force10 S4810P, Reference Manual

Page: 1318 / 1637

multicast (OPTIONAL) Enter the keyword
multicast
to match against
multicast traffic.
NOTE: This option is not supported on the C-Series or S-Series.
set-ip-dscp
value
(OPTIONAL) Enter the keywords
set-ip-dscp
followed by the IP
DSCP value. The matched traffic is marked with the DSCP value. The
range is 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added the keyword
multicast
. Added support for the
DSCP
marking
option for the S-Series.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.5.1.0 Added support for the
DSCP Marking
option.
pre-Version
6.1.1.1 Introduced on the E-Series.
Usage
Information
You must enter the
class-map
command in order to access this command. After the class
map is identified, you can configure the match criteria.
The
match ip precedence
command and the
match ip dscp
command are mutually
exclusive.
Up to eight precedence values can be matched in one match statement. For example, to
indicate the IP precedence values 0 1 2 3, enter either the
match ip precedence 0-3
or
match ip precedence 0,1,2,3
command.
NOTE: Only one of the IP precedence values must be a successful match criterion, not all
of the specified IP precedence values need to match.
Related
Commands
class-map – identifies the class map.
match mac access-group
Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax match mac access-group { mac-acl-name }
Parameters
mac-acl-name Enter a MAC ACL name. Its contents is used as the match criteria in
the class map.
1318