Dell Force10 S4810P, Reference Manual

Page: 1617 / 1637

Defaults
• C and S-Series default: VRRP is enabled.
• E-Series default: VRRP is disabled.
Command Modes VRRP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information To enable VRRP traffic, assign an IP address to the VRRP group using the
virtual-
address
command and enter
no disable
.
Related
Commands virtual-address – specifies the IP address of the virtual router.
hold-time
Specify a delay (in seconds) before a switch becomes the MASTER virtual router. By delaying the initialization of the
VRRP MASTER, the new switch can stabilize its routing tables.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax hold-time seconds
To return to the default value, use the
no hold-time
command.
Parameters
seconds
Enter a number of seconds. The range is 0 to 65535. The default is
zero (0) seconds.
Defaults zero (0) seconds
Command Modes VRRP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Usage
Information If a switch is a MASTER and you change the hold timer, you must disable and re-enable VRRP
for the new hold timer value to take effect.
1617