Dell Force10 S4810P, Reference Manual

Page: 574 / 1637

cam-optimization
Optimize CAM utilization for QoS Entries by minimizing require policy-map CAM space.
C-Series, S-Series, Z-Series
Syntax cam-optimization [qos]
Parameters
qos Optimize CAM usage for QoS.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.2.1.0 Introduced on the S-Series.
Version 7.8.1.0 Introduced on the C-Series.
Usage
Information When you enable this command, if a Policy Map containing classification rules (ACL and/or
dscp/ ip-precedence rules) is applied to more than one physical interface on the same port
pipe, only a single copy of the policy is written (only one FP entry is used).
NOTE: An ACL itself may still require more that a single FP entry, regardless of the number
of interfaces. For more information, refer to the “IP Access Control Lists”, “Prefix Lists”,
and “Route-map” sections in the
FTOS Configuration Guide
.
cam-profile
Set the default CAM profile and the required microcode.
E-Series
Syntax cam-profile profile microcode microcode
Parameters
profile Choose one of the following CAM profiles:
• Enter the keyword
default
to specify the default CAM
profile.
• Enter the keywords
eg-default
to specify the default
CAM profile for EG (dual-CAM) line cards.
• Enter the keywords
ipv4-320k
to specify the CAM profile
that provides 320K entries for the IPv4 forwarding information
base (FIB).
• Enter the keywords
ipv4-egacl-16k
to specify the CAM
profile that provides 16K entries for egress ACLs.
• Enter the keywords
ipv6-extacl
to specify the CAM
profile that provides IPv6 functionality.
• Enter the keywords
l2-ipv4-inacl
to specify the CAM
profile that provides 32K entries for ingress ACLs.
574