Dell Force10 S4810P, Reference Manual

Page: 308 / 1637

match interface
Configure a filter to match routes whose next hop is on the interface specified.
C-Series, E-Series, S-Series, Z-Series
Syntax match interface interface
To remove a match, use the
no match interface interface
command.
Parameters
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet
and then enter the slot/port information.
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet
and then enter the slot/ port
information.
• For the loopback interface, enter the keyword
loopback
and then enter a number from zero (0) to 16383.
• For a Port Channel interface, enter the keyword
port-
channel
and then enter a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet
and then
enter the slot/port information.
• For a Ten Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
and then enter the slot/port information.
• For a VLAN, enter the keyword
vlan
and then enter a
number from 1 to 4094 or 1 to 2094 for ExaScale (you can use
IDs 1 to 4094).
Defaults Not configured.
Command Modes ROUTE-MAP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0 Introduced on the E-Series.
Related
Commands
match ip address – redistributes routes that match an IP address.
match ip next-hop – redistributes routes that match the next-hop IP address.
308