Dell Force10 S4810P, Reference Manual

Page: 140 / 1637

When a soft reset is issued on a line card (
reset linecard number
), FTOS boots the
line card from its runtime image. Only when you enter
reset linecard number hard
is the software image reloaded on the line card.
Related
Commands
reload – reboots the system.
restore fpga-image – copies the backup C-Series FPGA image to the primary FPGA image.
rpm <slot> location-led
Toggle the location light emitting diode (LED) on/off on the E-Series ExaScale RPM (LC-EH-RPM).
E-Series ExaScale Only
Syntax rpm slot number location-led [on | off]
Parameters
rpm slot
number
Enter the slot number. For the E1200i, the range is 0-13. For the E600i,
the range is 0-6.
on |off Toggles the LED on the RPM on or off.
Defaults OFF
Command Modes EXEC
Command History
Version 8.2.1.0 Introduced on the E-Series ExaScale.
Usage
Information The LED setting is not saved through power cycles.
send
Send messages to one or all terminal line users.
C-Series, E-Series, S-Series, Z-Series
Syntax send [*] | [line ] | [aux] | [console] | [vty]
Parameters
* Enter the asterisk character
*
to send a message to all tty lines.
line Send a message to a specific line. Range: 0 to 11.
aux Enter the keyword
aux
to send a message to an auxiliary line.
NOTE: This option is supported on the E-Series only.
140