Dell Force10 S4810P, Reference Manual

Page: 824 / 1637

Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0 Introduced on the E-Series.
Example
FTOS(conf-if-po-1)#show config
!
interface Port-channel 1
no ip address
shutdown
FTOS(conf-if-po-1)#
show interfaces port-channel
Display information on configured Port Channel groups.
C-Series, E-Series, S-Series, Z-Series
Syntax show interfaces port-channel [ channel-number ] [brief]
Parameters
channel-number For a Port Channel interface, enter the keyword
port-channel
followed by a number. For the C-Series and S-Series, the range is 1 to
128. For the E-Series, the range is 1 to 255 for TeraScale and 1 to 512
for ExaScale.
brief (OPTIONAL) Enter the keyword
brief
to display only the port
channel number, the state of the port channel, and the number of
interfaces in the port channel.
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series. Modified to display the LAG failover
group status.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information The following describes the
show interfaces port-channel
command shown in the
Example below.
824