Dell Force10 S4810P, Reference Manual

Page: 129 / 1637

Parameters
aux 0 Enter the keyword
aux 0
to configure the auxiliary terminal
connection.
NOTE: This option is supported on E-Series only.
console 0 Enter the keyword
console 0
to configure the console port. The
console option for the S-Series is
<0-0>
.
vty
number
Enter the keyword
vty
followed by a number from 0 to 9 to configure
a virtual terminal line for Telnet sessions. The system supports 10
Telnet sessions.
end-number (OPTIONAL) Enter a number from 1 to 9 as the last virtual terminal line
to configure. You can configure multiple lines at one time.
Defaults Not configured
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
Usage
Information You cannot delete a terminal connection.
Related
Commands
access-class – restricts the incoming connections to a particular IP address in an IP access
control list (ACL).
password – specifies a password for users on terminal lines.
show linecard – displays the line card(s) status.
linecard
Pre-configure a line card in a currently empty slot of the system or a different line card type for the slot. To pre-configure
a 4-port 40G line card, refer to the
linecard
command.
C-Series, E-Series
Syntax linecard number card-type
Parameters
number Enter the number of the slot. For the C-Series, the range is 0 to 7. For
the E-Series, the range is 0 to 13 on the E1200/E1200i, 0 to 6 on the
E600/E6001, and 0 to 5 on the E300..
129