Dell Force10 S4810P, Reference Manual

Page: 245 / 1637

resequence prefix-list ipv4
Re-assign sequence numbers to entries of an existing prefix list.
C-Series, E-Series, S-Series, Z-Series
Syntax resequence prefix-list ipv4 { prefix-list-name StartingSeqNum
Step-to-increment }
Parameters
prefix-list-name
Enter the name of the configured prefix list, up to 140 characters long.
StartingSeqNum
Enter the starting sequence number to resequence. The range is 0 to
65535.
Step-to-
Increment
Enter the step to increment the sequence number. The range is 1 to
65535.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale
Version 7.8.1.0 Increased the name string to accept up to 140 characters. Prior to
7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
When you have exhausted all the sequence numbers, this feature permits re-assigning a new
sequence number to entries of an existing prefix list.
Related
Commands resequence access-list – resequences an access-list.
seq
Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax seq sequence-number {deny | permit} { source [ mask ] | any | host
ip-address }} [count [byte] | log] [dscp value ] [order]
[monitor] [fragments]
To delete a filter, use the
no seq sequence-number
command.
245