Dell Force10 S4810P, Reference Manual

Page: 1205 / 1637

00:00:09.111
LSA id: 3.3.3.3 Type: 1 Adv Rtid: 3.3.3.3 Expiry time:
00:00:23.96
FTOS#
show ip ospf topology
Display routers in directly connected areas.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip ospf process-id topology
Parameters
process-id
Enter the OSPF Process ID to show a specific process. If no Process
ID is entered, command applies only to the first OSPF process.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series and E-Series.
Usage
Information Use this command to isolate problems with inter-area and external routes. In OSPF inter-area
and external routes are calculated by adding LSA cost to the cost of reaching the router. If an
inter-area or external route is not of correct cost, the display can determine if the path to the
originating router is correct or not.
Example
FTOS#show ip ospf 1 topology
Router ID Flags Cost Nexthop Interface Area
3.3.3.3 E/B/-/ 1 20.0.0.3 Gi 13/1 0
1.1.1.1 E/-/-/ 1 10.0.0.1 Gi 7/1 1
FTOS#
show ip ospf virtual-links
Display the OSPF virtual links configured and is useful for debugging OSPF routing operations. If no OSPF virtual-links
are enabled on the switch, no output is generated.
C-Series, E-Series, S-Series
Syntax show ip ospf process-id virtual-links
NOTE: This command was deprecated.
1205