Dell Force10 S4810P, Reference Manual

Page: 63 / 1637

3
File Management
This chapter contains command line interface (CLI) commands needed to manage the configuration files as well as
other file management commands.
The commands in this chapter are supported by the Dell Force10 operating software (FTOS) on the E-Series, C-Series, S-
Series, Z-Series, S4810 and S4820T platforms.
boot config
Set the location and name of the configuration file that is loaded at system start-up (or reload) instead of the default
startup-configuration.
C-Series, E-Series
Syntax boot config {remote-first | rpm0 file-url | rpm1 file-url }
Parameters
remote-first Enter the keywords
remote-first
to attempt to load the boot
configuration files from a remote location.
rpm0 Enter the keywords
rpm0
first to specify the local boot configuration
file for route processor module (RPM) 0.
rpm1 Enter the keywords
rpm1
first to specify the local boot configuration
file for RPM 1.
file-url
Enter the location information:
• For a file on the internal Flash, enter
flash://
followed by
the filename.
• For a file on the external Flash, enter
slot0://
followed by
the filename.
Defaults Not configured
Command Modes CONFIGURATION
Command History
Version 7.5.1.0 Introduced on C-Series
E-Series Original command
Usage
Information To display these changes in the
show bootvar
command output, save the running
configuration to the startup configuration (
copy running-config startup-config
or write
).
63