Dell Force10 S4810P, Reference Manual

Page: 1031 / 1637

• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
followed by the slot/port information.
vlan
vlan-id
Enter the keyword
vlan
followed by a VLAN ID number from 1 to
4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 9.1(0.0) Added support for output range parameter for S4810 and Z9000.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.1 Introduced on the E-Series.
Example
(Unicast) mac-address-table static 00:01:00:00:00:01 {output Te 0/2 vlan
2}
Example
(Multicast) mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2
output—range Te 0/2,Te 0/3 }
Related
Commands show mac-address-table – displays the MAC address table.
mac-address-table station-move threshold
Change the frequency with which the MAC address station-move trap is sent after a MAC address changes in a VLAN. A
trap is sent if a station move is detected above a threshold number of times in a given interval.
C-Series, E-Series, S4810
Syntax [no] mac-address-table station-move threshold number interval
count
Parameters
threshold number Enter the keyword
threshold
followed by the number of times
MAC addresses in VLANs can change before an SNMP trap is sent.
The range is 1 to 10.
interval
seconds
Enter the keyword
interval
followed by the number of seconds.
The range is 5 to 60.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
Version 8.3.7.0 Introduced on the S4810.
1031