Dell Force10 S4810P, Reference Manual

Page: 59 / 1637

2. Enter the
protocol spanning-tree
stp-id
command.
You can return to CONFIGURATION mode by using the
exit
command
Per-VLAN SPANNING TREE (PVST+) Plus Mode
You must use PVST+ mode to enable and configure the Per-VLAN Spanning Tree (PVST+) protocol. For more
information, refer to
Per-VLAN Spanning Tree Plus (PVST+) .
NOTE: The protocol name is PVST+, but the plus sign is dropped at the CLI prompt.
To enter PVST+ mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
protocol spanning-tree pvst
command.
You can return to CONFIGURATION mode by using the
exit
command.
RAPID SPANNING TREE (RSTP) Mode
You must use RSTP mode to enable and configure RSTP. For more information, refer to Rapid Spanning Tree Protocol
(RSTP) .
To enter RSTP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
protocol spanning-tree rstp
command.
You can return to CONFIGURATION mode by using the
exit
command.
MULTIPLE SPANNING TREE (MSTP) Mode
You must use MULTIPLE SPANNING TREE mode to enable and configure MSTP. For more information, refer to Multiple
Spanning Tree Protocol (MSTP) .
To enter MULTIPLE SPANNING TREE mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
protocol spanning-tree mstp
command.
You can return to CONFIGURATION mode by using the
exit
command.
PROTOCOL GVRP Mode
You must use PROTOCOL GVRP mode to enable and configure GARP VLAN Registration Protocol (GVRP). For more
information, refer to GARP VLAN Registration (GVRP).
To enter PROTOCOL GVRP mode:
1. Verify that you are logged in to CONFIGURATION mode.
2. Enter the
protocol gvrp
command.
You can return to CONFIGURATION mode by using the
exit
command.
59