Dell Force10 S4810P, Reference Manual

Page: 296 / 1637

mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
mac-destination-
address Enter the destination MAC address and mask in nn:nn:nn:nn:nn:nn
format.
mac-destination-
address-mask
Specify which bits in the MAC address must be matched.
The MAC ACL supports an inverse mask; therefore, a mask of
ff:ff:ff:ff:ff:ff allows entries that do not match and a mask of
00:00:00:00:00:00 only allows entries that match exactly.
ethertype
operator
(OPTIONAL) To filter based on protocol type, enter one of the
following Ethertypes:
•
ev2
- is the Ethernet II frame format
•
llc
- is the IEEE 802.3 frame format
•
snap
- is the IEEE 802.3 SNAP frame format
count (OPTIONAL) Enter the keyword
count
to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword
byte
to count bytes processed by
the filter.
log (OPTIONAL, E-Series only) Enter the keyword
log
to log the packets.
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface.
NOTE: For more information, refer to the Flow-based Monitoring
section in the Port Monitoring chapter of the
FTOS Configuration
Guide
.
Defaults Not configured.
Command Modes CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added the
monitor
option.
pre-Version
6.1.1.0 Introduced on the E-Series.
296