Dell Force10 S4810P, Reference Manual

Page: 816 / 1637

management route – configures a static route that points to the Management interface or a
forwarding router.
stack-unit portmode
Split a single 40G port into 4-10G ports on the S4810 or Z9000.
S4810, Z-Series
Syntax stack-unit stack-unit port number portmode quad
Parameters
stack-unit
Enter the stack member unit identifier of the stack member to reset.
For the S4810, the range is 0 to 11. For the Z9000, the range is 0 to 7.
number
Enter the port number of the 40G port to be split. For the S4810, enter
one of the following port numbers: 48, 52, 56, or 60. For the Z9000, the
range is 0 to 124 in multiples of 4 (0, 4, 8, 12, ... 120 124).
Defaults Disabled.
Command Modes CONFIGURATION
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.1 Introduced on the S4810.
Usage
Information Splitting a 40G port into 4x10G port is supported only on a standalone unit.
• Split ports cannot be used as stack-link to stack an S4810.
• Split ports S4810 unit cannot be a part of any stacked system.
• The unit number with the split ports must be the default (stack-unit 0).
• This can be verified using CLI
show system brief
. If the unit ID is different than
0, it must be renumbered to 0 before ports are split by using the
stackunit id
renumber 0
command in EXEC mode.
The quad port must be in a default configuration before it can be split into 4x10G ports. The 40G
port is lost in the config when the port is split, so be sure the port is also removed from other
L2/L3 feature configurations.
The system must be reloaded after issuing the CLI for the change to take effect.
switchport
Place an interface in Layer 2 mode.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax switchport [backup interface {gigabit slot/port | tengigabit
slot/port | fortyGigE slot/port | port-channel number }]
To remove an interface from Layer 2 mode and place it in Layer 3 mode, enter the
no
switchport
command. If a switchport backup interface is configured, you must first remove
the backup configuration. To remove a switchport backup interface, enter the
no
816