Dell Force10 S4810P, Reference Manual

Page: 398 / 1637

To disable sending a COMMUNITY attribute, use the
no neighbor { ip-address |
peer-group-name } send-community
command.
Parameters
ip-address
Enter the IP address of the peer router in dotted decimal format.
peer-group-name
Enter the name of the peer group to send a COMMUNITY attribute to
all routers within the peer group.
extended Optional. Enter the keyword
extended
to send extended community
attribute.
standard Optional. Enter the keyword
standard
to send standard community
attribute.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information To configure a COMMUNITY attribute, use the
set community
command in ROUTE-MAP
mode.
neighbor shutdown
Disable a BGP neighbor or peer group.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax neighbor { ip-address | peer-group-name } shutdown
To enable a disabled neighbor or peer group, use the
neighbor { ip-address |
peer-group-name } no shutdown
command.
Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to disable or enable all routers
within the peer group.
Defaults Enabled (that is, BGP neighbors and peer groups are disabled.)
Command Modes ROUTER BGP
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
398