Dell Force10 S4810P, Reference Manual

Page: 288 / 1637

Parameters
any Enter the keyword
any
to specify that all routes are subject to the
filter.
mac-source-
address
Enter a MAC address in nn:nn:nn:nn:nn:nn format.
mac-source-
address-mask
(OPTIONAL) Specify which bits in the MAC address must match. If no
mask is specified, a mask of 00:00:00:00:00:00 is applied (in other
words, the filter allows only MAC addresses that match).
count (OPTIONAL) Enter the keyword
count
to count packets processed
by the filter.
byte (OPTIONAL) Enter the keyword
byte
to count bytes processed by
the filter.
log (OPTIONAL, E-Series only) Enter the keyword
log
to log the packets.
monitor (OPTIONAL) Enter the keyword
monitor
when the rule is describing
the traffic that you want to monitor and the ACL in which you are
creating the rule is applied to the monitored interface. For more
information, refer to the “Flow-based Monitoring” section in the Port
Monitoring chapter of the
FTOS Configuration Guide
.
Defaults Not enabled.
Command Modes CONFIGURATION-MAC ACCESS LIST-STANDARD
Command History
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Version 7.4.1.0 Added the
monitor
option.
Usage
Information
When you use the
log
option, the CP processor logs detail the packets that match. Depending
on how many packets match the log entry and at what rate, the CP may become busy as it has
to log these packets’ details.
NOTE: When ACL logging and byte counters are configured simultaneously, byte counters
may display an incorrect value. Configure packet counters with logging instead.
Related
Commands
permit – configures a MAC address filter to pass packets.
seq – configures a MAC address filter with a specified sequence number.
288