Dell Force10 S4810P, Reference Manual

Page: 1044 / 1637

Column Heading Description
• po — Port Channel followed by a number. The range is 1 to
255 for TeraScale.
• so — Sonet followed by a slot/port.
• te — 10-Gigabit Ethernet followed by a slot/port.
State Lists if the MAC address is in use (Active) or not in use (Inactive).
Example
FTOS#show mac-address-table
VlanId Mac Address Type Interface State
999 00:00:00:00:00:19 Sticky Gi 0/1 Active
999 00:00:00:00:00:29 Dynamic Gi 0/2 Active
FTOS#
Usage
Information The following describes the
show mac-address-table count
command shown in the
Example below.
Line Beginning With Description
MAC Entries... Displays the number of MAC entries learnt per VLAN.
Dynamic Address... Lists the number of dynamically learned MAC addresses.
Static Address... Lists the number of user-defined MAC addresses.
Total MAC... Lists the total number of MAC addresses used by the switch.
Example (Count)
FTOS# show mac-address-table count
MAC Entries for all vlans :
Dynamic Address Count : 110
Static Address (User-defined) Count : 0
Sticky Address Count : 0
Total Synced Mac from Peer(N): 100
Total MAC Addresses in Use: 110
FTOS#
Related
Commands show mac-address-table aging-time – displays MAC aging time.
show mac-address-table aging-time
Display the aging times assigned to the MAC addresses on the switch.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show mac-address-table aging-time [vlan vlan-id ]
Parameters
vlan
vlan-id
(OPTIONAL) Enter the keyword
vlan
followed by the VLAN ID to
display the MAC address assigned to the VLAN. The range is 1 to
4094.
Command Modes
• EXEC
• EXEC Privilege
1044